Section 1 - Identification of The Material and Supplier
Chemical nature: Paste consisting of petroleum distillates and additives
Trade Name: XDP905 Paste
Product Use: Cutting lubricant
Creation Date: June, 2017
This version issued: June, 2017 and is valid for 5 years from this date.
Section 2 - Hazards Identification
Statement of Hazardous Nature
This product is classified as: Not classified as hazardous according to the criteria of SWA.
Not a Dangerous Good according to Australian Dangerous Goods (ADG) Code, IATA or IMDG/IMSBC criteria.
SUSMP Classification: None allocated.
ADG Classification: None allocated. Not a Dangerous Good according to Australian Dangerous Goods (ADG) Code, IATA or IMDG/IMSBC criteria.
UN Number: None allocated
GHS Signal word: NONE. Not hazardous. HAZARD STATEMENT:
PREVENTION
P262: Do not get in eyes, on skin, or on clothing.
P281: Use personal protective equipment as required.
RESPONSE
P301+P330+P331: IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.
P370+P378: In case of fire, use carbon dioxide, dry chemical, foam.
STORAGE
P410: Protect from sunlight.
P402+P404: Store in a dry place. Store in a closed container.
DISPOSAL
P501: If they can not be recycled, dispose of contents to an approved waste disposal plant and containers to landfill (see Section 13 of this SDS).
Emergency Overview
Physical Description & Colour: Soft grease. No data regarding colour.
Odour: No data.
Major Health Hazards: no significant risk factors have been found for this product.
Section 3 - Composition/Information on Ingredients
Ingredients determined to be non-hazardous secret 100 not set not set
This is a commercial product whose exact ratio of components may vary slightly. Minor quantities of other non
hazardous ingredients are also possible.
The SWA TWA exposure value is the average airborne concentration of a particular substance when calculated over a normal 8 hour working day for a 5 day working week. The STEL (Short Term Exposure Limit) is an exposure value that may be equalled (but should not be exceeded) for no longer than 15 minutes and should not be repeated more than 4 times per day. There should be at least 60 minutes between successive exposures at the STEL. The term "peak "is used when the TWA limit, because of the rapid action of the substance, should never be exceeded, even briefly.
Section 4 - First Aid Measures
General Information:
SAFETY DATA SHEET
Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand
You should call The Poisons Information Centre if you feel that you may have been poisoned, burned or irritated by this product. The number is 13 1126 from anywhere in Australia (0800 764 766 in New Zealand) and is available at all times. Have this SDS with you when you call.
Inhalation: No first aid measures normally required. However, if inhalation has occurred, and irritation has developed, remove to fresh air and observe until recovered. If irritation becomes painful or persists more than about 30 minutes, seek medical advice.
Skin Contact: Gently brush away excess particles. Wash gently and thoroughly with water (use non-abrasive soap if necessary) for 5 minutes or until chemical is removed.
Eye Contact: Quickly and gently brush particles from eyes. No effects expected. If irritation does occur, flush contaminated eye(s) with lukewarm, gently flowing water for 5 minutes or until the product is removed. Obtain medical advice if irritation becomes painful or lasts more than a few minutes. Take special care if exposed person is wearing contact lenses.
Ingestion: If product is swallowed or gets in mouth, do NOT induce vomiting; wash mouth with water and give some water to drink. If symptoms develop, or if in doubt contact a Poisons Information Centre or a doctor.
Section 5 - Fire Fighting Measures
Fire and Explosion Hazards: The major hazard in fires is usually inhalation of heated and toxic or oxygen deficient (or both), fire gases. There is no risk of an explosion from this product under normal circumstances if it is involved in a fire.
Fire decomposition products from this product may be toxic if inhaled. Take appropriate protective measures. Extinguishing Media: In case of fire, use carbon dioxide, dry chemical or foam.
Fire Fighting: If a significant quantity of this product is involved in a fire, call the fire brigade.
Flash point:
Upper Flammability Limit: Lower Flammability Limit: Autoignition temperature: Flammability Class:
Not flammable. No data.
No data.
No data.
No data.
Section 6 - Accidental Release Measures
Accidental release: Minor spills do not normally need any special cleanup measures. In the event of a major spill, prevent spillage from entering drains or water courses. As a minimum, wear overalls, goggles and gloves. Suitable materials for protective clothing include PVC and Nitrile. Eye/face protective equipment should comprise, as a minimum, protective glasses and, preferably, goggles. If there is a significant chance that dusts are likely to build up in cleanup area, we recommend that you use a suitable dust mask. Otherwise, not normally necessary.
Stop leak if safe to do so, and contain spill. Sweep up and shovel or collect recoverable product into labelled containers for recycling or salvage, and dispose of promptly. Consider vacuuming if appropriate. Recycle containers wherever possible after careful cleaning. After spills, wash area preventing runoff from entering drains. If a significant quantity of material enters drains, advise emergency services. This material may be suitable for approved landfill. Ensure legality of disposal by consulting regulations prior to disposal. Thoroughly launder protective clothing before storage or re-use. Advise laundry of nature of contamination when sending contaminated clothing to laundry.
Section 7 - Handling and Storage
Handling: Keep exposure to this product to a minimum, and minimise the quantities kept in work areas. Check Section 8 of this SDS for details of personal protective measures, and make sure that those measures are followed. The measures detailed below under "Storage" should be followed during handling in order to minimise risks to persons using the product in the workplace. Also, avoid contact or contamination of product with incompatible materials listed in Section 10.
Storage: Store packages of this product in a cool place. Make sure that containers of this product are kept tightly closed. Keep containers dry and away from water. Protect this product from light. Make sure that the product does not come into contact with substances listed under "Incompatibilities" in Section 10. Check packaging - there may be further storage instructions on the label.
Section 8 - Exposure Controls and Personal Protection
The following Australian Standards will provide general advice regarding safety clothing and equipment:
Respiratory equipment: AS/NZS 1715, Protective Gloves: AS 2161, Occupational Protective Clothing: AS/NZS 4501 set 2008, Industrial Eye Protection: AS1336 and AS/NZS 1337, Occupational Protective Footwear: AS/NZS2210. Exposure limits have not been established by SWA for this product.
SAFETY DATA SHEET
Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand)
Issued by: Excision Saws and Supplies
Phone: 1800 633 448 (office hours)
No special equipment is usually needed when occasionally handling small quantities. The following instructions are for bulk handling or where regular exposure in an occupational setting occurs without proper containment systems. Ventilation: This product should only be used where there is ventilation that is adequate to keep exposure below the TWA levels. If necessary, use a fan.
Eye Protection: Eye protection such as protective glasses or goggles is recommended when this product is being used.
Skin Protection: You should avoid contact even with mild skin irritants. Therefore you should wear suitable impervious elbow-length gloves and facial protection when handling this product for lengthy periods. See below for suitable material types.
Protective Material Types: We suggest that protective clothing be made from the following materials: PVC, nitrile. Respirator: If there is a significant chance that dusts are likely to build up in the area where this product is being used, we recommend that you use a suitable dust mask. Otherwise, not normally necessary.
Section 9 - Physical and Chemical Properties:
Physical Description & colour: Odour:
Boiling Point: Freezing/Melting Point: Volatiles:
Vapour Pressure: Vapour Density: Specific Gravity: Water Solubility: pH:
Volatility:
Odour Threshold: Evaporation Rate:
Coeff Oil/water Distribution: Viscosity:
Autoignition temp:
Soft grease. No data regarding colour. No data.
Not available.
300°C
No data.
No data.
Not applicable. No data. Insoluble.
No data.
No data.
No data.
Not applicable. No data
Not applicable. No data.
Section 10 - Stability and Reactivity
Reactivity: This product is unlikely to react or decompose under normal storage conditions. However, if you have any doubts, contact the supplier for advice on shelf life properties.
Conditions to Avoid: This product should be kept in a cool place, preferably below 30°C. Keep containers tightly closed. Containers should be kept dry. Protect this product from light.
Incompatibilities: strong oxidising agents.
Fire Decomposition: Combustion forms carbon dioxide, and if incomplete, carbon monoxide and possibly smoke.
Water is also formed. Carbon monoxide poisoning produces headache, weakness, nausea, dizziness, confusion, dimness of vision, disturbance of judgment, and unconsciousness followed by coma and death. Polymerisation: Polymerisation reactions are unlikely; they are not expected to occur.
Section 11 - Toxicological Information
Local Effects:
Target Organs: There is no data to hand indicating any particular target organs.
Classification of Hazardous Ingredients
No ingredient mentioned in the HSIS Database is present in this product at hazardous concentrations.
Potential Health Effects
Inhalation:
Short Term Exposure: Available data indicates that this product is not harmful. However product may be mildly irritating, although unlikely to cause anything more than mild transient discomfort.
Long Term Exposure: No data for health effects associated with long term inhalation.
Skin Contact:
SAFETY DATA SHEET
Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand)
Issued by: Excision Saws and Supplies
Phone: 1800 633 448 (office hours)
Short Term Exposure: Available data indicates that this product is not harmful. It should present no hazards in normal use. However product may be irritating, but is unlikely to cause anything more than mild transient discomfort. Long Term Exposure: No data for health effects associated with long term skin exposure.
Eye Contact:
Short Term Exposure: This product may be irritating to eyes, but is unlikely to cause anything more than mild transient discomfort.
Long Term Exposure: No data for health effects associated with long term eye exposure.
Ingestion:
Short Term Exposure: Significant oral exposure is considered to be unlikely. However, this product may be irritating to mucous membranes but is unlikely to cause anything more than transient discomfort.
Long Term Exposure: No data for health effects associated with long term ingestion.
Carcinogen Status:
SWA: No significant ingredient is classified as carcinogenic by SWA. NTP: No significant ingredient is classified as carcinogenic by NTP. IARC: No significant ingredient is classified as carcinogenic by IARC.
Section 12 - Ecological Information Section
Insufficient data to be sure of status
13 - Disposal Considerations
Disposal: This product may be recycled if unused, or if it has not been contaminated so as to make it unsuitable for its intended use. If it has been contaminated, it may be possible to reclaim the product by filtration, distillation or some other means. If neither of these options is suitable in-house, consider controlled incineration, or contact a specialist waste disposal company.
Section 14 - Transport Information
UN Number: This product is not classified as a Dangerous Good by ADG, IATA or IMDG/IMSBC criteria. No special transport conditions are necessary unless required by other regulations.
Section 15 - Regulatory Information
AICS: This product is compliant with NICNAS regulations.
Section 16 - Other Information
This SDS contains only safety-related information. For other data see product literature. Acronyms:
Insufficient data to be sure of status.
ADG Code AICS
SWA
CAS number Hazchem Code
IARC
NOS
NTP R-Phrase SUSMP
UN Number
Australian Code for the Transport of Dangerous Goods by Road and Rail (7th edition) Australian Inventory of Chemical Substances
Safe Work Australia, formerly ASCC and NOHSC
Chemical Abstracts Service Registry Number
Emergency action code of numbers and letters that provide information to emergency services especially firefighters
International Agency for Research on Cancer
Not otherwise specified
National Toxicology Program (USA)
Risk Phrase
Standard for the Uniform Scheduling of Medicines & Poisons United Nations Number
THIS SDS SUMMARISES OUR BEST KNOWLEDGE OF THE HEALTH AND SAFETY HAZARD INFORMATION OF THE PRODUCT AND HOW TO SAFELY HANDLE AND USE THE PRODUCT IN THE WORKPLACE. EACH USER MUST REVIEW THIS SDS IN THE CONTEXT OF HOW THE PRODUCT WILL BE HANDLED AND USED IN THE WORKPLACE.
IF CLARIFICATION OR FURTHER INFORMATION IS NEEDED TO ENSURE THAT AN APPROPRIATE RISK ASSESSMENT CAN BE MADE, THE USER SHOULD CONTACT THIS COMPANY SO WE CAN ATTEMPT TO OBTAIN ADDITIONAL INFORMATION FROM OUR SUPPLIERS
OUR RESPONSIBILITY FOR PRODUCTS SOLD IS SUBJECT TO OUR STANDARD TERMS AND CONDITIONS, A COPY OF WHICH IS SENT TO OUR CUSTOMERS AND IS ALSO AVAILABLE ON REQUEST.
Please read all labels carefully before using product.
Poisons Information Centre: 13 1126 from anywhere in Australia, (0800 764 766 in New Zealand)
This SDS is prepared in accord with the SWA document “Preparation of Safety Data Sheets for Hazardous Chemicals - Code of Practice” (Feb 2016)
Copyright © Kilford & Kilford Pty Ltd, June, 2017.